System Control/Level Algorithms; Patch Bay; Preamp Select - Art SGX-NightBass User Manual

Start allows you to trim the beginning of the sample removing annoying clicks,
unwanted sample material or dead space.
Level sets the amount of signal level coming out of the Sampler.
Use the Short Sampler, [SAMPLER-S] when you want to combine a sampled sound with
reverb. The algorithms from reverb groups one and two are available. Every time
the sample is played back it will be subjected to the reverb parameters you have
set.
The Long Sampler [SAMPLER-L] should be used when you require one and a half
seconds of sampling time.
You should use the Sampler with Pitch Transposer [SAMPLER+PTr] algorithm when you
want to shift the pitch of the sample during playback. Each time the sample is
played back it will be subjected to the pitch parameters set.
NOTES:
1) The Low Pass filter [LPF] acts as a high frequency rolloff to the signal
before it is sampled and may be added to all three algorithm choices.
2) You may program the Remote Jacks to access the Trigger and Re-Arm feature.
3) BASE KEY in the SAMPLER + PTr algorithm has no effect on triggering samples.
4) You cannot store an audio sample.
5) See APPENDIX A, for more information regarding the SAMPLER.

SYSTEM CONTROL/LEVEL ALGORITHMS

PATCH BAY

[PATCH BAY], [PBY]
Parameters:
DRY = [INPUT] INPUT, POST CMP
LOOP1 = [IN] OUT, IN
LOOP2 = [IN] OUT, IN
Use the Patch Bay to route the input "dry" signal either pre or post compressor
to the programmable Mix control. When set to Input, only "dry" signal taken
directly after the Drive control is sent to the Programmable Mix [DRY] parameter.
When set to Post CMP, the signal first passes through the compressor and then
sent to the Programmable Mix [DRY] parameter.
To insert the Effects Loops into the preset, add the Patchbay. By adding the
Patchbay, you control whether the effect plugged into the effects loop is "in" or
"out" when the preset is selected. Setting the Loop = to IN allows the effect to
be in when the preset is recalled. You may assign a MIDI controller to change the
value between IN and OUT.
NOTE: The Master Overide switches on the front panel must be "In" for the Loops
to be active in a preset.

PREAMP SELECT

[PREAMP SLCT], [PRS]
Parameter:
PRS: [BRITE TUBE] BRITE TUBE, SMOOTH SOLID, SMOOTH TUBE, 2ND EQ OFF
35