Rec/Arm; Trigger; Title Edit - Art SGX-NightBass User Manual

easy to delete stored presets. Presets 116 through 200 are null when you receive
your unit or after a factory reset.

REC/ARM

YOU MUST BE USING A PRESET SET UP
FOR SAMPLING AND IN THE EDIT MODE FOR THIS FUNCTION TO OPERATE
To reset the NIGHTBASS to record a new sample, press the REC/ARM button.
While you are using any of the Sampler algorithms you will need to "reset" the
record parameter to be ready to record another sample. The REC/ARM button allows
you to return the Sampler to Record-Ready status. Pressing this button wipes out
the existing sample.

TRIGGER

YOU MUST BE USING A PRESET SET UP
FOR SAMPLING AND IN THE EDIT MODE FOR THIS FUNCTION TO OPERATE
This button allows you to either record or play back a sample of the program
material.
When you first recall a Sampler preset it is usually geared up and ready to
record a sample. Most of the Factory Presets using the Sampler in the NIGHTBASS
are "record/ready". When the preset is recalled and signal is presented to the
NIGHTBASS, recording is automatically triggered.
Now you may replay this sample as recorded at any time by pressing the Trigger
button. If the PLAY parameter is set in the SINGLE position and you hit the
button quickly and repeatedly, you will get that stuttering "rap" effect. The
sampled sound can also be played back by a MIDI note on message, using a
footswitch connected to a properly programmed REMOTE jack, or audio trigger.
You may determine the length of the sample time regardless of the Length
parameter's value in the Preset with this button. Say your Length is set for 1.50
seconds and you feel the sample should end at a specific point less than 1.5
seconds. All you need to do is press the TRIGGER button once when you feel the
sample should stop. This automatically sets the Length parameter to that amount
of time.
NOTES:
1) You will have to reset the LENGTH parameter back to its original value if the
full length is required. To do this, simply hit the RECALL button. Doing this
will restore the LENGTH parameter to its original value. (It is assumed the
preset has been STORED)
2) You cannot store the audio sample in the NIGHTBASS or dump it through MIDI.

TITLE EDIT

One of the displays to appear in the upper portion of the LCD is the title of the
preset. There is a total of sixteen spaces with the complete ASCII character set
available to use in naming presets.
To either edit the title or create a new one you must first enter the Edit Mode.
-Press the Edit Mode button.
-Press the Title Edit button
*[Title Edit] appears in the top half of the display and a cursor appears in the
bottom half.
-Press the Value button and use the Encoder to select characters.
14