Boost; Punch; Brilliance; Tube Contour - Art SGX-NightBass User Manual

BOOST

At 250Hz, control the upper end of your lows and lower mids to add some depth to
the signal.

PUNCH

1KHz is the center point of this band. Use it to color and fill in the sound.

BRILLIANCE

The frequency center is 3.0KHz and allows you enhance the upper midrange.

TUBE CONTOUR

Use this control to vary the harmonic balance sound of the tube. As you turn the
control from left to right the frequency goes from low to high. Accent your sound
at various frequencies to bring out the extra growl, punch, or edge to your tube
distortion sound. The most neutral setting for this control is 12:00.
CROSSOVER FREQUENCY
To set the crossover frequency points when you are bi-amping, adjust this
control. The frequency range is 40Hz to 800Hz. For example, if the control is set
at 250Hz, frequencies below 250Hz will be sent to the Low Crossover Output Jack
and frequencies above 250Hz will be sent to the High Crossover Output jack.

CROSSOVER BALANCE

This control adjusts the balance of Low and High signal level sent to the Low and
High Crossover outputs. Using this control allows you to keep your amplifier set
at one level and adjust your sound to have a heavy bottom/light top, or heavy
top/light bottom.

STEREO MASTER OUTPUT

The final output level present at the Headphone, Line, and Crossover Outputs is
set with this control.

PUSH SWITCHES

MASTER OVERIDE:

EFX LOOP 1

Switches Effect Loop 1 in and out. When the switch is in, the effects loop is
engaged.

EFX LOOP 2

Switches Effect Loop 2 in and out. When the switch is in, the effects loop is
engaged.
NOTE: The switches must be in and you must use the Patch Bay algorithm to insert
and delete outboard gear for use in a preset.

CONTROL BUTTONS

The buttons on the front panel engage or select the different functions of the
NIGHTBASS. Modes of operation are indicated by LED's. When the LED is lit the
function is active.
Ten of the control buttons serve a dual purpose. The split functions are set
apart by color. While you are in the PRESET MODE (standard operating mode), all
buttons labeled in purple are active. When the EDIT MODE is engaged, the numbered
8