Regen-Ddl-S; Regen-Ddl-L - Art SGX-NightBass User Manual

are closer together. As the taps approach the set delay in the Lengthened mode
they are farther apart. In the types you will see an [m] and an [s], the [m]
means mono and the [s] signifies stereo. The mono tapped delay has its left and
right taps at the same delay points where the stereo taps are staggered. When
using the stereo tapped delays the first right tap is half the delay time before
the first left tap.
There also are three slopes used in the tapped delays, Flat, Reverse and Forward.
Flat has a flat linear response. Reverse increases in amplitude exponentially as
the signal approaches the end. Forward exponentially decreases in amplitude as
the signal approaches its end point.
TYPE 3 taps are dense and full. Use the longer tapped delay programs to add some
expansiveness to short reverb patches. Use the longer tapped delays especially
the Sloped algorithms to create a fundamental front end reverb.

REGEN-DDL-S

[REGEN-DDL-S], [DDL]
Regenerated Digital Delay - Short
Parameters:
:DELAY* = [100ms] 0 to 960ms
increments:5ms;0-350, 10ms;350-700
20ms;700-960
D-FINE* = [0ms] 0 to 50ms in 1ms increments
:REGENeration = [76%] 0 to 100 percent in % increments
:LEVEL= [100%] 0 to 100 percent in % increments
*Total delay possible is 1010ms.
Since this delay algorithm has the characteristic of being in parallel with a
reverb program if used with one, it can be used to add a small amount of depth,
or wrap-around effect to the sound. A "hard reverb" effect may be achieved by
using longer delay and a moderate amount of regeneration. Tonal sounding drones
may be found using short delay and large amounts of regeneration.

REGEN-DDL-L

[REGEN-DDL-L], [DDL]
Regenerated Digital Delay - Long
Parameters:
:DELAY* = [200ms] 0 to 1100ms
increments:5ms;0-350, 10ms;350-700
20ms;700-1000, 50ms;1000-1100
D-FINE* = [0ms] 0 to 50ms in 1ms increments
:REGENeration = [50ms] 0 to 100 percent in % increments
:LEVEL= [100%] 0 to 100 percent in % increments
*Total delay possible is 1150ms
Use this algorithm for the same reasons and applications as the short Regen-DDL,
only using longer delay times.
32