Linearization (Ltb) - Siemens SITRANS LR250 Operating Instructions Manual

Linearization (LTB)

You can use the linearization feature to define a more complex vessel shape and enter up
to 32 level breakpoints where the corresponding volume is known. (See
on page 101.)
Navigate to Configure/Setup > LTB > Setup > Linearization and click on Linearization. Click on
the Vessel Shape tab to access the parameters listed:
Vessel Shape
• Vessel Shape (see
Vessel Dimensions
• Maximum Volume (see
• Vessel Dimension A (see
• Vessel Dimension L (see
OR
Click on Breakpoints tab for access to level and volume breakpoints.
This parameter becomes accessible only after Linearization Table
Note:
has been selected in Vessel Shape above.
Level and Volume Breakpoints (see XY Index (2.4.1.5.) on page 103)
• Level 1 .... Level 32
• Volume 1 ... Volume 32
• Vessel Shape
7ML19985KL01
2.4.1.1. Vessel Shape
2.4.1.2. Maximum Volume
2.4.1.3. Dimension A
2.4.1.4. Dimension L
SITRANS LR250 (FF) – OPERATING INSTRUCTIONS
2.4. Linearization
)
on page 101
on page 103)
on page 103)
on page 103)
Page 53