®
Intellex
144
Live Filter Configuration
Digital Video Management System Installation and Operating Instructions
filter to ensure its proper activation. More lighting in the
area will allow higher sensitivity settings to be safely
used.
NOTE: You can only configure one perimeter protection target
area at a time.
1.
Set the Sensitivity: 1 to 100.
2.
Move the mouse pointer to the image area. The mouse
pointer changes to
3.
Draw the boundaries of the target area.
NOTE: The target area must be enclosed to activate the filter.
a.
Move the mouse pointer to the first corner of the target
area and click the mouse button.
NOTE: To erase the last endpoint, double-click the right mouse
button.
b. Move the mouse pointer to the next corner of the target
area. The unit draws a line as the pointer moves.
NOTE: The pointer changes to
location.
c.
Click the mouse button to lock this boundary and start a
new one.
d. Repeat these steps until you are ready to enclose the
target area.
e.
Use one of the following methods to enclose the target
area:
Set at least three endpoints. Then hold the mouse pointer
over the last endpoint and double-click the button. The
boundary lines disappear and the target area is defined by a
semitransparent grid.
Move the mouse pointer to the starting point and click the
mouse button. The boundary lines disappear and the target
area is defined by a semitransparent grid.
Click Apply to apply the configuration for this filter as shown
and close the Perimeter Protection screen. Click Cancel to cancel
the changes and return to the previous screen.
.
if it is dragged to an invalid
MORE>>>