American Dynamics Intellex DV8000 Installation And Operating Instructions Manual page 14

®
Intellex
14
Optional Connections
Alarms
Video Out
Keyboard
Network
Installing the Intellex Unit
Digital Video Management System Installation and Operating Instructions
CAUTION: Do not apply power until you have connected all
optional items. The Intellex unit will start operating
immediately once power is applied.
CAUTION: Protect the unit against lightning. If a portion of a
cable is installed outside of a building, the entire
cable is vulnerable to lightning. Therefore, install
protection devices on all vulnerable cables.
The alarm connectors include pins for mechanical or TTL/CMOS
standard alarm inputs and outputs. Connect up to 8 alarm inputs
and 8 alarm outputs. (See
assignments and additional information.)
The Video Out connector provides continuous live video, even
during image playback. Connect this output to the video input of
an optional live monitor (NTSC/EIA or PAL/CCIR).
If installing a keyboard, plug it into the keyboard connector.
NOTE: Do NOT connect the Intellex unit to a network unless you
also install the Network Client on the network.
NOTE: We recommend the use of shielded twisted-pair cable for
network operation.
Connect the cable from the local area network to Connector 15
(Network). Use Category 5 twisted-pair Ethernet cable (CAT 5
TPE).
Refer to the Network Client instructions for more information.
Alarm Connectors for specific pin
MORE>>>