American Dynamics DV16000 Installation And Operating Instructions Manual page 16

®
Intellex
16
Mouse
Optional Connections
Cameras Out
Alarms
Video Out
Keyboard
Printer
Com1
Video Out
Installing the Intellex Unit
Digital Video Management System Installation and Operating Instructions
Connect the power cable to the unit.
Connect the mouse (or other pointing device) to the Mouse
connector.
The Camera Out connectors pass through the live video signal
from the Camera In connectors.
To add a loop-through device, connect the cable from the loop-
through device to the appropriate Camera Out connector. Then
select Hi-Z for the camera in the Cameras portion of the Setup
Options screen.
To remove a loop-through device, disconnect the cable from the
appropriate Camera Out connector. Then select 75 Ohms
termination for the camera in the Cameras portion of the Setup
Options screen.
CAUTION: Protect the unit against lightning. If a portion of a
cable is installed outside of a building, the entire
cable is vulnerable to lightning. Therefore, install
protection devices on all vulnerable cables.
The alarm connectors include pins for mechanical or TTL/CMOS
standard alarm inputs and outputs. Connect up to 16 alarm
inputs and 16 alarm outputs. (See
pin assignments and additional information.)
The Video Out connector provides continuous live video, even
during image playback. Connect this output to the video input of
an optional live monitor (NTSC/EIA or PAL/CCIR).
If installing a keyboard, plug it into the keyboard connector.
Connect this output to a parallel printer that supports graphics.
Connect this input to a dome controller (Sensormatic VM16 or
American Dynamics ADTT16) using an external interconnect
module (EIM). Refer to the dome controller documentation for
more information.
The S-VID OUT connector provides live and recorded camera
images, as well as system configuration and status information.
Alarm Connectors for specific
MORE>>>