Setting-History Log - Siemens SIPROTEC 5 Manual

Operation in the Operating State
8.5 Logs
Deletability
The ground-fault log of your SIPROTEC 5 device can be deleted. Read details about this in chapter
8.5.12 Saving and Deleting the
Configurability
The indication scope of the ground-fault log is configured in a specifically defined column of the information
routing (matrix) of DIGSI 5:
Target → Log → Column Ground-fault log
Selected application templates and functions from the library already bring a predefined set of operational
indications with them which you can adjust individually at any time.

Setting-History Log

8.5.5
All individual setting changes and the downloaded files of entire parameter sets are recorded in the log for
setting changes. This enables you to determine setting changes made are associated with events logged (for
example faults). On the other hand, it is possible to obtain verification with fault analyses, for example, that
the current status of all settings truly corresponds to their status at the time of the fault. Up to 200 indications
can be stored in the setting-history log.
Reading from the PC with DIGSI 5
•
To reach the log for setting changes of your SIPROTEC 5 device, use the project-tree window.
Project → Device → Process data → Log → Setting changes
The status of the setting-history log last loaded from the device is shown to you.
•
To update (synchronization with the device), click the Read log entries button in the headline of the
indication list
[scparamd-030211-01, 1, en_US]
Figure 8-20
Reading on the Device through the On-Site Operation Panel
•
To reach the setting-history log from the main menu, use the navigation keys of the on-site operation
panel.
Main menu → Indications → Setting changes
•
You can navigate within the displayed indication list using the navigation keys (up/down) on the on-site
operation panel.
164
Logs.
(Figure 8-20).
Reading the Setting-History Log with DIGSI 5
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-C, Edition 08.2020