Setting Up The Scalance M-800 And The Network - Siemens SIMATIC NET SCALANCE M-800 Getting Started

1.2

Setting up the SCALANCE M-800 and the network

Note
Note the security instructions in the operating instructions before you commission the device.
Procedure
1. Unpack the SCALANCE M-800 and check the device for damage.
2. Only with with the SCALANCE M87x: Insert the SIM card.
3. Connect the power supply.
4. Connect the device to the network. This step depends on the device and the type of
network:
– SCALANCE M87x (mobile wireless network): Mount the antenna.
– SCALANCE M81x (ADSL): Connect the device to the DSL socket on the splitter.
– SCALANCE M826 (SHDSL): Wire X1 with X2, for detailed information refer to the
5. Connect an Ethernet port (P1, P2, P3, P4) to the PC.
6. Turn the device on. After connecting up, the fault LED (F) is lit red
7. Now, turn on the PC.
SCALANCE M-800
Getting Started, 07/2020, C79000-G8976-C337-09
WARNING
Use safety extra-low voltage only
The SCALANCE M874 is designed for operation with safety extra-low voltage. This
means that only safety extra-low voltages (SELV) complying with IEC950/EN60950/
VDE0805 can be connected to the power supply terminals.
The power supply unit for the SCALANCE M power supply must meet NEC Class 2,
according to the National Electrical Code(r) (ANSI / NFPA 70).
section "Connecting SCALANCE M826 to SHDSL".
Connecting SCALANCE M-800 to WAN
1.2 Setting up the SCALANCE M-800 and the network
11