2.6.6
Codec Configuration
Jumper groups JG5, JG11, JG16, and JG17 enable and configure the on-board MC145483
codec.
2.6.6.1
Codec Enabling
Jumper group JG5 configures the on-board codec. The default setting is JG5 1–2, 3–4, 5–6,
and 7–8 for the MC145483 codec. If a different codec or another peripheral requires the
use of PC8/STD, PC9/SRD, PC10/STCK, and PC11/STFS, all the jumpers should be
removed from JG5. See Table 2-6 for JG5 codec configuration.
Configuration
On-board codec (default)
User application
Note:
The DSP56824ADM is factory configured for the MC145483 codec.
2.6.6.2
Codec Input Connector Signal Selection
Jumper group JG16 is used to select which signal on J4 is sent to the codec. See Table 2-7
for JG16 configuration information.
NC (default)
MOTOROLA
Table 2-6 Codec Selection
JG5
1–2, 3–4, 5–6, 7–8
no jumpers
Table 2-7 Codec Input Signal Selection
JG16
Input signal from tip of stereo jack
1–2
Input signal from tip and ring of stereo jack
DSP56824ADM User's Manual
DSP56824ADM Technical Summary
Jumper Configuration
Comment
Enable MC145483 codec
Other peripheral
Comment
2-13