Configuration; Alternate Power Sources - Motorola G24-L Technical Information

Configuration

Configuration
After performing Initial Setup (previous section), you can continue using the Developer Board
this default setup. This section describes how to change the default setup so you can use different
peripherals or change default board operation.
Note:

Alternate Power Sources

The Developer Board power can be supplied from:
•
Wall mount power adapter
•
External DC power source
A single power source is used for the G24-L and the board peripherals.
You must connect the Developer Board to a power source, and then set the power source jumper
(P204), if necessary
Two other jumpers
•
P201
•
P200
Figure 2-7: Power Supply Connectors, Jumpers and Switches
Each power supply option is described in the sections that follow.
12
Except for the Disconnecting Power paragraph, the following section does not apply to
G24-L Charger model. Refer to
(see "Wall Mount Adapter Operation" on page
(see "DC Power Source Operation" on page
(see "Selecting the Power Source" on page
(Figure 2-7) help control the power supply in the Developer Board:
—Connects/disconnects the power from the Developer Board peripherals
—Connects/disconnects the power from the G24
G24-L Developer's Kit
"G24-LC (Charger Model)" on page C-1
15).
for details.
13)
14)
September 25, 2007