Installation Procedure; Preparing The Dsp56824Adm - Motorola DSP56824ADM User Manual

Quick Start Guide

Installation Procedure

• Hewlett Packard HP7xx Workstation running HPUX Version 9.x (Version 10.x is
not supported), one open EISA expansion slot, CD-ROM drive, and a mouse
• Sun Microsystems Sun 4 Workstation running Sun Operating System Release
4.1.1 or later (or Solaris Release 2.5 or later), one open SBus expansion slot, a
CD-ROM drive, and a mouse
1.3 INSTALLATION PROCEDURE
Installation requires four basic steps:
1. Preparing the DSP56824ADM board
2. Installing the module
3. Installing the software
4. Testing the installation
1.3.1

Preparing the DSP56824ADM

Because all electronic components are sensitive to the effects of
electrostatic discharge (ESD) damage, correct procedures should be
used when handling all components in this kit and inside the
supporting personal computer. Use the following procedures to
minimize the likelihood of damage due to ESD:
– Always handle all static-sensitive components only in a protected area,
preferably a lab with conductive (anti-static) flooring and bench surfaces.
– Always use grounded wrist straps when handling sensitive components.
– Never remove components from anti-static packaging until required for
installation.
– Always transport sensitive components in anti-static packaging.
Locate the jumper blocks JG1–JG17 on the DSP56824ADM board, as shown in Figure 1-1.
Table 1-1 describes the jumper group settings for use with the Motorola ADS. Read the
1-4
CAUTION
DSP56824ADM User's Manual MOTOROLA