Dsp56824Adm Connector Descriptions; Table 2-14 Pb15 Selection; Table 2-15 Dsp56824Adm Connectors - Motorola DSP56824ADM User Manual

Configuration
PB15 pull-up (default)
PB15 pull-down
Note: The DSP56824ADM is factory configured for clock frequencies between
2 MHz and the maximum frequency of the DSP.
2.7

DSP56824ADM CONNECTOR DESCRIPTIONS

There are seven connectors on the DSP56824ADM. Table 2-15 describes the connectors.
Connector
J1
J2
J3
J4
J5
J6
J7
MOTOROLA

Table 2-14 PB15 Selection

JG10
Open Clock frequencies 2 MHz to maximum DSP frequency
1–2 Clock frequencies 32 KHz–2 MHz

Table 2-15 DSP56824ADM Connectors

70-pin Expansion Connector 1 (bottom of board)
70-pin Expansion Connector 2 (bottom of board)
14-pin JTAG/OnCE Module Interface to DSP
1/8" Stereo Line Input Jack to Codec (Mono Signal)
1/8" Stereo Line Output Jack from Codec (Mono Signal)
DB9 RS-232 serial Interface connector
Power Connector
DSP56824ADM User's Manual
DSP56824ADM Technical Summary

DSP56824ADM Connector Descriptions

Comment
Comment
2-17