Repair; Replace The Eeprom Storage; Cleaning - TCS PUK Series Product Information

20 Ohm:
max. 160 m distance AS/IS-VS by 0.6 mm diameter
max. 300 m distance AS/IS-VS by 0.8 mm diameter

Replace the EEPROM storage

All programmed data such as serial numbers and parameters are stored in the EEPROM.
If the door loudspreaker has to be exchanged, the EEPROM board can be removed from
the programmed front-door station and inserted into a new, identical constructed front-door
station.
!
Before replacing the EEPROM switch off the supply voltages!
Note: Every front-door station of the serien PUK is fitted with an EEPROM.
 Open the housing, respectively row.
 Pull off the small PCB from the electronic circuit board.
 Put the EEPROM boards into the new, unprogrammed front-door stations onto the pins.
Make sure that all four poles of the pin are plugged into the socket of the small PCB and
that the component site can be seen.
 After the exchange, all programming are available again.
Avoid water from entering the device!
!
Do not use any abrasive detergents!
Clean the device with a dry or slightly wet cloth.
Remove stronger stains with a standard plastic cleaner.
TCS TürControlSysteme AG, TCS Hotline Germany: +49 (0) 41 94/ 9 88 11 88
FAX: +49 (0) 41 94/ 9 88 129  Mail: info@tcsag.de
14
AS front-door station
VS power supply and control unit
IS indoor station
FE extended function

Repair

Cleaning

a, b short-circuit
here
Subject to technical changes.
PI_PUK-uk 1 A
11/2012