Fault Indicators - Nortel Communication Server 1000E Maintenance Manual

6
ATTENTION
Using the STAD command
Effective in CS 1000, Release 5.0, only users that have SEC_ADMIN privileges
can change the system time and date. For more information about security
enhancements, see Security Management Fundamentals (NN43001-604).
7
8
9

Fault indicators

When there is a fault in the system, you can receive notification by any
combination of the following indicators:
•
system messages
•
visual fault indicators
•
user reports
LD 135
MIDN
End the session in LD 135 and log out of the system by entering:
**** (four asterisks)
LOGO
The midnight routine runs now.
Check system messages produced when the midnight routine
runs. Clear any faults indicated.
If a sysload occurred while clearing a fault, reset the correct time
and date by entering:
LD 2
STAD (day) (month) (year) (hour) (minute) (second)
Check the time and date entered:
TTAD
End the session in LD 2 and log out of the system:
**** (four asterisks)
LOGO
Replace any covers that were removed.
Tag defective equipment with a description of the fault and return
it to a repair center.
Nortel Communication Server 1000
Communication Server 1000E Maintenance
NN43041-700 04.01 4 June 2010
Copyright © 2004-2010 Nortel Networks. All Rights Reserved.
Fault indicators 73
--End--