Signaling Servers For Dtls - Nortel Communication Server 1000E Maintenance Manual

52 Hardware maintenance tools
Table 13
NTAK09/NTRB21 LEDs (cont'd.)
Affected
circuit card LED
NTAK93 DCH
or
NTBK51
Monitor jacks
The NTAK09, NTAK10, NTAK79, NTBK50, and NTRB21 have two bantam
jacks (RCV and XMT) on the faceplate. They are used to monitor the
performance of the carrier in the receive and transmit direction. The jacks
allow the convenient connection of external T1/E1 test equipment and
ISDN protocol analyzers.

Signaling servers for DTLS

The supported hardware for the Communication Server 1000 system with
Datagram Transport Layer Security (DTLS) is as follows:
•
Communication Server 1000E Call Processors
—
—
—
—
•
CS 1000E Signaling Servers
—
—
—
—
—
—
•
IP Phones -- IP Softphone 1100, 1200, and Phase II series of Nortel IP
Phones (including Nortel IP Phone 2007) support DTLS.
State Definition
On (Red) The D-channel daughterboard is equipped and
disabled.
On (Green) The D-channel daughterboard is equipped and
enabled.
Off The D-channel daughterboard is not equipped.
Call Processor Pentium IV (CP PIV)
Common Processor Pentium Mobile (CP PM)
Co-resident Call Server and Signaling Server (all supported
platforms)
Gateway Controller
CP PM card
Common Processor Dual Core (CP DC) card
HP DL320 G4
IBM x306m
IBM x3350
Dell R300
Nortel Communication Server 1000
Communication Server 1000E Maintenance
NN43041-700 04.01 4 June 2010
Copyright © 2004-2010 Nortel Networks. All Rights Reserved.