Maintenance - Agilent Technologies TriScroll 800 Installation And Operation Manual

Maintenance

General Information
Agilent TriScroll 800 Inverter pump is designed to provide years of trouble-free service if maintenance procedures and intervals
are observed. Bearing grease replenishment and tip seal replacement is recommended when pump base pressure has risen to an
unacceptably high level for your application. Bearings, rotary seals and O-rings should also be replaced if the pump exhibits hum-
ming or grinding noises from the bearings. Main bearing life may be shortened if your application requires the pumping of high
quantities of water vapor. Use of the bearing purge kit (PTSPURGEKIT) mentioned earlier will keep this water from impacting
bearing life.
Maintenance should be performed in accordance with procedures, tooling and materials specified in the manuals listed below.
Related TriScroll Manuals
Other manuals related to tip seal replacement, pump module replacement, and major maintenance of the TriScroll 800 Inverter
pump are listed in Table 10.
Tip Seal Replacement Manual
Maintenance and Tooling Kits
Material and tooling required to perform maintenance on TriScroll pumps is provided in kit form. A description of each kit and
ordering information is provided in Table 11.
Description
Tip Seal Tool Kit
Replacement Tip Seal Set
NOTE
After tip seal replacement, the TriScroll
800 Inverter pump may require up to
100 hours run time to achieve full rota-
tional speed.
38
Table 10
Title
Table 11
Contents
All tools required to change the tip
seals on the TriScroll 800 Series
pumps.
Replacement tip seals and static
O-rings for TriScroll 800 Series
pumps.
Other Related Manuals
Applicable TriScroll Model
All TriScroll 800 Series models
Maintenance and Tooling Kits
Applicable TriScroll Model
All TriScroll 800 Series models
All TriScroll 800 Series models
Part Number
699904310
Part Number
PTSTSTKIT
PTSS0800TS
TriScroll 800 Inverter Vacuum Pump