Dimplex VFE 20 Installation And Operating Instructions Manual page 47

Commissioning
P11 - auxiliary heating Yes/No
NOTE
The auxiliary heating is available as an accessory and
is not installed at the factory.
Enter whether operation is to take place with or with-
out auxiliary heating.
Call up the installer menu.
Confirm the PIN code four times with the ENTER
key. Display P9 flashes.
Use the keys to select P11. Display flashes.
Press the ENTER key. ON flashes.
Operation with auxiliary heating:
Press the ENTER key. Setting is complete.
Operation without auxiliary heating:
Use the keys to select OFF. OFF flashes.
Press the ENTER key. Setting is complete.
P12 - release signal
Function for future charge release directly on the stor-
age heater. Currently without function.
NOTE
This menu item may be shown or not shown depend-
ing on the version. Do not change the setting values!
www.dimplex.eu
P13 - release manual
NOTE
Only required if there is a continuous voltage on the
terminals L1, L2, L3 and no release takes place by the
energy supplier or grid operator.
Call up the installer menu.
Confirm the PIN code four times with the ENTER
key. Display P9 flashes.
Use the
Press the ENTER key. A1 flashes.
Press the ENTER key. The hours display flashes.
Use the
the release.
NOTE
When entering the release times, always start with the
lowest hour, e.g. 00:00.
Example:
The release times 22:00 to 06:00 and 14:00 to 16:00
should be set.
Set A1 ON to 00:00 and A1 OFF to 06:00.
Set A2 ON to 14:00 and A2 OFF to 16:00.
Set A3 ON to 22:00 and A2 OFF to 23:59.
A4 ON and A4 OFF remain on 23:59.
P14 - Failing charge control signal
If due to an error the signal of the central charge con-
trol fails the heater will be charged to maximum.
In order to change to no charging please proceed as
described below.
Call up the installer menu.
Confirm the PIN code four times with the ENTER
key. Display P9 flashes.
Use the
Press the ENTER key. ON flashes.
Use the
Press the ENTER key. Setting is complete.
2007/A
keys to select P13. Display flashes.
keys to set the hour for the start of
keys to select P14. Display flashes.
keys to select OFF. OFF flashes.
English
EN-21