Table of Contents
Advertisement
TROUBLESHOOTING
OBSERVATION
Machine fills slowly and/or the
rinse is weak.
Doors will not close
completely.
Water leaks at wash pump.
Ware is not coming clean.
07610-003-92-84-T
POSSIBLE CAUSE
1. Clogged or obstructed
rinse arms.
2. Low incoming water pressure.
3. Y-strainer is clogged.
1. Improper spring tension.
2. Obstruction in door channel.
1. Wash pump seal is defective.
2. Petcock or pump drain leaking.
1. Machine temperatures are not
up to the minimum requirements.
2. No detergent/too much
detergent.
TROUBLESHOOTING
REMEDY
1. Remove and clean the rinse arms.
2. Adjust the water pressure regulator to ensure that
there is 15 PSI water flow pressure.
3. Clean out the Y-strainer.
1. Adjust spring tension as required by loosening
(not removing) spring bolt nuts and adjusting the
tension. Tighten nuts when done.
2. Remove the obstruction.
1. Replace wash pump seal.
2. Close shut or tighten.
1. Verify that incoming water temperature meets
requirements listed on the machine data plate.
2. Adjust detergent concentration as required for the
amount of water held by the machine. (Contact the
chemical supplier before making any changes.)
25
Advertisement
Table of Contents
