Jackson Conserver XL-E Series Installation, Operation And Service Manual page 24

INSTALLATION
PLANT TEST MODE
After 15 seconds of no
button being pressed,
the timer exits
the plant test mode.
If more than one input
is on, the first letters
of each will show
(e.g. "Drain-DH" indicates
the DRAIN output and
DoorClosed and Heavy
inputs are on).
07610-003-92-84-T
CYCLE TIMER INSTRUCTIONS
1. Press and hold CYCLE COUNT button and DOWN ARROW button (under STEP
START TIME) simultaneously for 3–4 seconds.
SELECT CYCLE STEP TO ADJUST
CYCLE
2. Press and hold the DRAIN button. The DRAIN output stays on while the button
is held. The output turns off when the button is released. Repeat for the other
seven buttons (use SAVE/EXIT to activate CYCLE output, use CYCLE COUNT
to activate PUMP output). Second row of display shows outputs and inputs that
are active.
Outputs
CYCLE
Cycle
Wash
Drain
Fill
Sani
Deter
Rinse
Spare
3. Plant test mode can also be used to prime chemicals if the machine has no
priming function. Open door and press and hold the SANI button until sanitizer
is seen entering the wash sump/tank and no air is in the line.
SELECT CYCLE STEP TO ADJUST
CYCLE
4. Repeat for DETER and RINSE AID buttons.
PRESS SAVE TO EXIT
RINSE
PUMP DRAIN FILL SANI DETER
AID
PLANT TEST
CYCLE
COUNT
-DoorClosed
STEP STEP
START TIME DURATION
SAVE
EXIT
SELECT MODEL
SELECT CYCLE STEP TO ADJUST PRESS SAVE TO EXIT
RINSE
PUMP DRAIN FILL SANI DETER
AID
PLANT TEST
CYCLE
COUNT
Drain-DoorClosed
STEP STEP
START TIME DURATION
SAVE
EXIT
SELECT MODEL
PRESS SAVE TO EXIT
RINSE
PUMP DRAIN FILL SANI DETER
AID
PLANT TEST
CYCLE
COUNT
Deter-Start
STEP STEP
START TIME DURATION
SAVE
EXIT
SELECT MODEL
SPARE
DISH
CYCLE
TIMER
TIMER
MODEL
Inputs
SPARE
DoorClosed
Start
DISH
CYCLE
TIMER
TIMER
MODEL
SPARE
DISH
CYCLE
TIMER
TIMER
MODEL
16