Jackson Conserver XL-E Series Installation, Operation And Service Manual page 23

INSTALLATION
RESETTING TO
FACTORY DEFAULTS
Firmware version
changes, so number will
be different depending on
when timer was installed.
CHECKING CYCLE
COUNT
07610-003-92-84-T
CYCLE TIMER INSTRUCTIONS
1. Press and hold CYCLE COUNT button and DOWN ARROW button (under STEP
DURATION) simultaneously for 3–4 seconds.
2. Resets all settings to factory defaults for the active model. Cycle count is
unaffected by the reset.
3. Firmware version on the Home screen shows "F" at the end, indicating the timer
is now set to factory defaults for the active model.
1. Press CYCLE COUNT button. Cycle count will show on display.
SELECT CYCLE STEP TO ADJUST PRESS SAVE TO EXIT
RINSE
CYCLE PUMP DRAIN FILL SANI DETER
AID
START DURATION
CYCLE
COUNT
1.50 5.00
STEP STEP
START TIME DURATION
SAVE
EXIT
SELECT MODEL
SELECT CYCLE STEP TO ADJUST PRESS SAVE TO EXIT
RINSE
CYCLE PUMP DRAIN FILL SANI DETER
AID
JACKSON WWS
CYCLE
COUNT
SW v30013F
STEP STEP
START TIME DURATION
SAVE
EXIT
SELECT MODEL
SELECT CYCLE STEP TO ADJUST PRESS SAVE TO EXIT
RINSE
CYCLE PUMP DRAIN FILL SANI DETER
AID
CYCLE COUNT:
CYCLE
COUNT
12
STEP STEP
START TIME DURATION
SAVE
EXIT
SELECT MODEL
SPARE
DISH
CYCLE
TIMER
TIMER
MODEL
SPARE
"M" = Modifed Timing
"F" = Factory Defaults
DISH
CYCLE
TIMER
TIMER
MODEL
SPARE
DISH
CYCLE
TIMER
TIMER
MODEL
15