Installing The System; Before You Begin; Installing The System On A Table Top - 3Com CoreBuilder 3500 Getting Started Manual

I
NSTALLING THE
2
This chapter describes how to install your
CoreBuilder ® 3500 system on a table top or in a
distribution rack.
To install the system on a table top, read these
instructions:

Before You Begin

Installing the System on a Table Top

To install the system in a distribution rack, read
these sections:
Before You Begin
Installing the System in a Distribution Rack
Before You Begin
Before you begin the installation procedures, be sure
that you:
Move the system close to where you plan to
install it.
Have a No. 2 Phillips screwdriver available.
Have the system mounting kit available. See
Table 5.
S
YSTEM
Table 5 System Mounting Kit
Item
Rubber feet (self-
adhesive)
Mounting bracket
8-32 x 1/2 Phillips flat-
head screws
10-32 x 1/2 Phillips
pan-head screws
Installing the System on a Table Top
To install the system on a table top:
Place the system on its side on the table.
1
Remove the protective covering from each rubber
2
foot to expose the adhesive surface.
Place one rubber foot in each of the marked areas at
3
the corners of the bottom of the system.
Turn the system onto its feet.
4
Ensure that nothing blocks the air intake and fan
5
exhaust vents.
You are now ready to install the media modules into
the system. For installation instructions, see Chapter 3
or the guides that are shipped with the modules.
Qty To use in
4 Table top installation
2 Installing the system in the
distribution rack
8 Installing distribution-rack
mounting brackets
4 Installing the system in the
distribution rack