Quick start guide
3. Make sure the seal/no seal lever is set to the seal position (all the way to the left) as shown here.
4. Place the envelopes on the feed deck and tap the Start button on the Print on Envelopes screen.
Note: If the moistener tank is full and your envelopes do not seal correctly, clean or replace the
moistener brush and wick.
Sealing the envelope only, bypass all printing
1. Tap Print on Envelopes.
2. Tap Print Mode on the lower left side of the Envelope Printing mail screen. You may have to
swipe up on the screen to see this option.
3. Swipe up on the Print Mode screen and tap Seal Only.
4. Tap Apply.
5. Load the envelopes onto the feeder with the flap side facing down and the top edge against the
rear wall.
Pitney Bowes
Operator Guide
November 2019
21