Direct Key Programming
Use the following procedure to select direct-key programming:
Direct key
You can assign departments and PLUs directly to the keyboard. In the case of PLUs, you may assign up to
3 levels to be accessed directly on the keyboard. For key no. positions, refer to the illustration shown below.
You can also select a key by directly pressing the corresponding direct key assigned on the keyboard.
Procedure
Select a pertinent key no.
from the key numbers list,
or directly press the key
on the keyboard.
128
In the case of selecting "069 DIRECT PLU"
• TYPE (Use the selective entry)
PLU:
Assigns the key as a direct PLU key.
DEPT:
Assigns the key as a direct department key.
NOTE
When selecting a department, the screen on which a department code is to
be entered (the message "DEPT. CODE") will appear.
• LEVEL1 through 3 (Use the numeric entry)
Enter a PLU code for each level. For example, if you want to use this
key as PLU code 1 (level 1) and PLU code 101 (level 2), enter 1 for
"LEVEL1" and 101 for "LEVEL2."
Key numbers
NOTE
• You can assign departments and PLUs only the "Departments and PLUs
programmable area" shown above.
• You cannot assign a department or a PLU to the position to which a
function key has been assigned.
51
57
63
50
56
62
49
55
61
48
54
60
47
53
59
Departments and PLUs programmable area
69
68
67
66
65