IBM Netfinity ServeRAID-4L Ultra160 User Reference page 20

Figure 2. Inserting a ServeRAID-4H controller into the PCI expansion slot
10. Connect one end of a 68-pin ANSI standard cable (separately purchased or
1. ANSI stands for American National Standards Institute.
® ®
6
IBM Netfinity : ServeRAID
8. Secure the controller by either tightening the expansion-slot screw on the top
of the controller or closing the latch, depending on your server.
9. Connect the SCSI cables to the controller. If you intend to attach external
devices only, go to step 13 on page 7. Otherwise, continue with step 10.
already in your server) to the internal channel connector on the ServeRAID
controller.
Note: See "Connector locations" on page 3 for the channel connector
locations.
™
-4L Ultra160 SCSI Controller User's Reference