Selecting A Special Mode - Sharp MX-M1100 Quick Start Manual

SELECTING A SPECIAL MODE

The procedure for selecting a special mode for image send is explained below. The settings that must be selected
vary for each special mode, however, the general procedure is the same. As an example, the procedure for
"ERASING PERIPHERAL SHADOWS ON THE IMAGE (Erase)" is explained.
The side to be scanned
must be face up!
(2)
Scan Internet Fax Fax
Address Book
Original Scan: Auto
(1)
Address Entry
Exposure Auto
Send Settings Resolution 200X200dpi
Address Review File Format PDF
Colour Mode Auto/Greyscale
File
Special Modes
Quick File
(3)
Scan/Special Modes
Program
Erase
(4)
Suppress
Timer
2in1
Background
Job Mixed Size
Build Original
Original
File
Count
Scan/Special Modes
Erase
Edge Centre Edge+Centre
Erase Erase Erase
Side Erase
82
1
2
Data Entry USB Mem. Scan
A4 Send: Auto
Text
PDF
OK
Dual Page
Scan
1
Card Shot 2
Slow Scan
Mode
Quick File
OK
(6)
Cancel OK
Edge
15
(0~20)
mm
(5)
3
Place the originals.
When using the document glass, place the original with the
side to be scanned face down.
Select settings in the touch panel.
(1) Specify the destination.
For the procedures for specifying a destination, see
"CONVENIENT TRANSMISSION METHODS" (page
72).
(2) Make sure that the desired mode ([Scan] tab)
is selected.
(3) Touch the [Special Modes] key.
(4) Touch the [Erase] key.
The erase settings will be configured to erase a width
of 3/4" around the edges of the original.
(5) Set the erasure width to 15 mm with the
keys.
The erase area is set to "Edge Erase" by default.
To select "Centre Erase", "Edge+Centre Erase" or
"Side Erase" touch the appropriate key.
(6) Touch the [OK] key.
Press the [START] key.
Cancel scanning