Selecting A Special Mode - Sharp MX-2300G Quick Start Manual

SELECTING A SPECIAL MODE

The procedure for selecting settings for a special mode is explained below. The settings that must be selected
vary for each special mode, however, the general procedure is the same. The procedure for selecting settings for
"Adding margins (Margin Shift)" is explained below as an example.
The side to be scanned must be face up!
Ready to scan for copy.
Full Colour
Colour Mode
Job Detail
Settings
Auto
1.
Exposure
2.
3.
100%
4.
Copy Ratio
Special Modes
Margin Shift
Erase
(2)
Job
Pamphlet Copy
Build
Special Modes
Margin Shift
Right Left Down
34
0
2-Sided Copy
Original A4
Output
Plain
A4
Special Modes
A4
(1)
A4R File
B4
A3
Quick File
OK
1/4
Dual Page
Copy
Tandem
Copy
OK
(4)
Cancel OK
Side 1 Side 2
(0~20) (0~20)
15 15
mm mm
(3)
or
1
Place the original.
When using the document glass, place the original
with the side to be scanned face down.
2
Select the desired special mode
(example: margin shift) settings in the
touch panel.
(1) Touch the [Special Modes] key.
(2) Touch the [Margin Shift] key.
Settings to shift the left margin by 15 mm will be
selected.
(3) Select 15 mm for the front side and
15 mm for the reverse side using the
keys.
(4) Touch the [OK] key.
The margin shift position is initially set to
"Right".
To change the position to "Left" or "Down",
touch the corresponding key.
3
Set the number of copies and then press
the [COLOUR START] key or the [BLACK
& WHITE START] key.
Correct sets Cancel scanning Cancel copying