Selecting A Special Mode - Sharp MX-7001N Quick Start Manual

SELECTING A SPECIAL MODE

The procedure for selecting settings for "Adding margins (Margin Shift)" is explained below as an example.
Although the specific settings for each special mode vary, the general procedure is the same.
The side to be scanned must be face up!
Colour Mode
Full Colour
Exposure 1. 2.
A4 A4
Auto
3. A3
B4
4.
Copy Ratio
Original Paper Select
100%
Auto
Auto
A4
Plain
Special Modes
Margin Shift Erase
(2)
Job
Pamphlet Copy
Build
Transparency
Covers/Inserts Multi Shot
Inserts
Book Copy Tab Copy
Special Modes
Margin Shift
Right Left Down Side 1
15
1
2
Special Modes
(1)
2-Sided Copy
Plain
A4
Output
File
Quick File
A4
OK
Dual Page
Copy
1
Tandem
2
Copy
Card Shot
OK
(4)
Cancel OK
Side 2
15
(0~20) (0~20)
mm mm
(3)
3
or
Place the originals.
When using the document glass, place the original with the
side to be scanned face down.
Select settings in the touch panel.
(1) Touch the [Special Modes] key.
(2) Touch the [Margin Shift] key.
Shifting the left margin by 15 mm will be explained as
an example.
(3) Select 15 mm for the front side and 15 mm for
the reverse side using the
The margin shift position is initially set to "Right".
To change the position to "Left" or "Down", touch the
corresponding key.
(4) Touch the [OK] key.
Set the number of copies and then press the
[COLOUR START] key or the [BLACK & WHITE
START] key.
Correct sets
keys.
Cancel scanning Cancel copying
39