Selecting A Special Mode - Sharp MX-2301N Quick Start Manual

SELECTING A SPECIAL MODE

The procedure for selecting settings for "Adding margins (Margin Shift)" is explained below as an example.
Although the specific settings for each special mode vary, the general procedure is the same.
The side to be scanned must be face up!
Ready to scan for copy.
Full Colour
Colour Mode
Job Detail
Settings
Auto
1.
Exposure
2.
3.
100%
4.
Copy Ratio
Special Modes
Margin Shift Erase
(2)
Job
Pamphlet Copy
Build
Special Modes
Margin Shift
Right Left Down
0
2-Sided Copy
Original
A4
Output
Plain
A4
Special Modes
A4
(1)
A4R
File
B4
A3 Quick File
OK
1/4
Dual Page
Copy
Tandem
Copy
OK
(4)
Cancel OK
Side 1 Side 2
(0~20) (0~20)
15 15
mm mm
(3)
1
Place the originals.
When using the document glass, place the
original with the side to be scanned face down.
2
Select settings in the touch panel.
(1) Touch the [Special Modes] key.
(2) Touch the [Margin Shift] key.
Shifting the left margin by 15 mm will be
explained as an example.
(3) Select 15 mm for the front side and
15 mm for the reverse side using
the keys.
The margin shift position is initially set to
"Right".
To change the position to "Left" or "Down",
touch the corresponding key.
(4) Touch the [OK] key.
3
Set the number of copies and then
press the [COLOUR START] key or
the [BLACK & WHITE START] key.
Cancel scanning
Correct sets
Cancel copying
35