Touchpad Cable - HP ENVY 15 Maintenance And Service Manual

Touchpad cable

Table 5-13 Touchpad cable spare part information
Description
Touchpad cable
Before removing the touchpad cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Heat sink (see
c. Fans (see
d. System board (see
Remove the touchpad cable:
1. Turn the system board upside down with the front toward you.
2. Release the ZIF connector (1) to which the touchpad cable is connected, and then disconnect the touchpad
cable (2) from the system board.
Reverse this procedure to install the touchpad cable.
Bottom cover on page
Battery on page 29)
Heat sink on page 35)
Fans on page 37)
System board on page
27), and then remove the following components:
52)
Component replacement procedures
Spare part number
L97416-001
55