Connector Board - HP ENVY 15 Maintenance And Service Manual

Connector board

Table 5-10 Connector board spare part information
Description
Connector board (includes USB port, audio jack, and rubber bumper)
Before removing the connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the heat sink (see
Remove the connector board:
1. Release the ZIF connector (1) to which the connector board cable is connected, and then disconnect the
connector board cable from the system board.
2. Detach the connector board cable (2) from the keyboard/top cover. (The connector board cable is attached
to the keyboard/top cover with double-sided adhesive.)
3. Remove the Phillips M2.0×3.0 screw (3) that secures the connector board to the keyboard/top cover.
4. Remove the connector board (4).
Reverse this procedure to install the connector board.
50 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 29).
Heat sink on page 35).
27).
Spare part number
L97396-001