Touchpad Cable - HP 17-u199 Maintenance And Service Manual

TouchPad cable

Description
TouchPad cable (includes double-sided adhesive)
Before removing the TouchPad cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the TouchPad cable:
1. Release the ZIF connector (1) to which the TouchPad cable is connected, and then disconnect
the TouchPad cable from the system board.
2. Release the ZIF connector (2) to which the TouchPad cable is connected, and then disconnect
the TouchPad cable from the TouchPad board.
3. Detach the TouchPad cable (3) from the TouchPad. (The TouchPad cable is attached to the TouchPad
with double-sided adhesive.)
4. Remove the TouchPad cable (4).
Reverse this procedure to install the TouchPad cable.
30 Chapter 5 Removal and replacement procedures
Bottom cover on page 26).
Spare part number
857836-001
Battery on page 28).