Low Birth Weight Harness Shortening Routing - Baby Trend Trooper CV01 Owner's Manual

5.0 Installation and Use

5.13 Low Birth Weight Harness Shortening Routing

1. Remove the head pillow and set aside
(Fig. 41a).
2. Remove the harness loop ends from the
splitter plate and pull harness through
the seat back.
See section (5.10 Page 38).
3. Remove harness cover, chest clip and
buckle tongue on one side and set
aside. Remove the cup holder and set
aside (Fig. 41b).
4. Pull harness webbing through the insert.
Remove the seat insert and set aside.
5. Lift seat fabric from the top and pull
crotch buckle through while removing
the complete seat fabric.
6. Must use crotch buckle in position 1.
Always put crotch buckle and place into
position 1 (Fig. 41c).
7. Pull the crotch buckle anchor through to
position 2 (Fig. 41c).
Seat Cut-Away
Buckle
Anchor Bracket
3 2 1
Fig. 41c
41
Fig. 41a
Fig. 41b
Fig. 41d
Copyright © 2021, Baby Trend, Inc.
5.13 Low Birth Weight Harness Shortening Routing cont.
8. From top side feed harness loop down though bottom
of seat slot (1).
9. Turn car seat over and feed harness loop end back
through slot (2).
10. Turn car seat upright and feed through harness
slot (3).
11. On opposite side, Turn seat over and feed harness
loop through slot number (3).
12. From top side feed harness loop end down through
slot number (2).
13.Turn seat over and feed harness end up through slot
number (1).
3 2 1
Copyright © 2021, Baby Trend, Inc.
5.0 Installation and Use
Shoulder height
levels
Numbered Slot
adjustments
1 2 3
1
Crotch buckle
2
adjustments
3
42