Forward Facing Installation With Lap Belt And Top Tether - Baby Trend Trooper CV01 Owner's Manual

5.0 Installation and Use
4. Route seat belt through forward facing
belt path (Fig. 31a).
5. Put weight in seat with hand to compress
the vehicle seat cushion then insert the
buckle tongue into the buckle and adjust
seat belt as tight as possible (Fig. 31b).
6. Pull seat fabric up and over the top of the
car seat. Then, install the pillow (Fig. 31c).
7. Pull up on buckle as to ensure the
buckle is secure. Please refer to the
vehicle owner's manual to determine if
your vehicle lap/shoulder belt includes a
lockable retractor and how to lock it.
8. Attach Top Tether to a designated anchor
point. Pull Top Tether strap until webbing
strap is snug (Fig. 31d).
NOTE: Your vehicle owner's manual will
give the anchor locations and maximum
weight of the car seat's occupant for LATCH
connections.
9. Check for movement of the car seat at the
safety belt path. The car seat should not
move more than 1 inch in any direction. If
the car seat moves more than 1 inch repeat
all steps until all safety steps are met.
31
Fig. 31a
Fig. 31b
Fig. 31c
Fig. 31d
Copyright © 2021, Baby Trend, Inc.

5.6 Forward Facing Installation with Lap Belt and Top Tether

Requirements. See section 2.2:
• Weight is 23 - 65 lbs
(10.43 - 29.48 kg)
• Height is 50 inches (127 cm) or less.
• Age is 1 year old.
1. Place the car seat in a rear seating position. Always adjust the
recline foot to the upright position when forward facing.
2. Ensure vehicle is level and that the car seat is placed and rests on
the front outer edge of the vehicle seat.
3. Loosen harness by pressing the center
adjuster and pulling on harness. Pull top
of seat fabric down to expose the forward
facing belt path (Fig. 32a).
Copyright © 2021, Baby Trend, Inc.
5.0 Installation and Use
Top Tether
Fig. 32a
32