Shoulder Height Adjustment - Baby Trend Trooper CV01 Owner's Manual

5.0 Installation and Use
4. Insert the buckle tongues into the
buckle (Fig. 37a).
NOTE: Pull up and test buckle tongues
to be sure they are secure.
5. Place chest clip at arm pit level
(Fig. 37b). Insert chest clip tabs and
press together. Pull outward on chest
clip's ends to be sure it is secure.
6. Pull on the harness tension adjuster
to tighten harness straps. The strap
should not allow any slack. The strap
should not press on to the child's
skin or push the child's body into an
unnatural position. Harness Covers are
required in all forward facing and rear
facing position except the Low Birth
weight harness routing (Fig. 37c).
To Loosen Harness System
Tension, push the harness
tension adjuster button
(Fig. 37d) located
underneath the seat fabric
and gently pull on the
harness straps over the
child's shoulder.
37
Fig. 37a
Fig. 37b
Fig. 37c
Fig. 37d
Copyright © 2021, Baby Trend, Inc.

5.10 Shoulder Height Adjustment

1. Shoulder Height Positions Facing Direction
Rear Facing: Positions 1, 2 and 3. Forward
Facing: Positions 3, 4 and 5 (Fig. 38a).
Height Adjustment
1. Loosen harness, unfasten harness end
loops from splitter plate. Pull harness end
loops through seatback. Thread harness
end loops through desired shoulder
postion (Fig. 38b).
2. Fasten harness end loop to splitter plate.
Ensure the harness strap ends are fully
hooked on the splitter plate. Both sides
must be threaded in the same position
(Fig. 38c).
Copyright © 2021, Baby Trend, Inc.
5.0 Installation and Use
5
4
3
2
1
Fig. 38a
5
4
3
2
1
Fig. 38b
3
2 2
1 1
Fig. 38c
3
38