Rear Facing Installation With Lap/Shoulder Belt - Baby Trend PROtect Series Owner's Manual

5.0 Installation and Use

5.2 Rear Facing Installation with Lap/Shoulder Belt.

Requirements. See section 2.1:
Weight is 5 - 22 lbs (2.3 - 10 kg)
The top of head has NOT reached max
height red line on seat back. Refer to
warning label on top of seat for reference.
Routing paths for rear facing installation with or without headrest
Lap belt
WARNING
Never use a Top Tether connector in a rear facing
installation!!
The Convertible car seat, in a Rear Facing installation, was designed with a
removable upper seatback to allow for a proper installation when the upper seatback
comes in contact with the front seat. If the upper seatback comes in contact with the
front seat and prevents a 45 degree installation, remove the upper seatback and
install the Convertible at 45 degrees per the instructions in this section. To remove
the upper seatback refer to section 5.15 and read all WARNINGS.
Reinstall the upper seat back when child reaches 22 lbs. (9.98 kg.), or the top of the
child's head has NOT reached max height red line on seat back. Keep child rear
facing as long as possible. If you have any questions regarding the use of the upper
seat back or any other questions please contact Baby Trend Customer Service at
1-800-328-7363.
17
Without headrest
Lap/Sholder belt Lower anchor
Copyright © 2018, Baby Trend, Inc.
5.0 Installation and Use
Rear Facing Installation with Lap/Shoulder Belt. With Headrest.
Requirements. See section 2.2:
Weight is between 5 and 40 lbs (2.3 kg and 18.1 kg),
and head is 1 inch below the top of the seat.
1. Squeeze recline handle and recline the seat to
positions 1, 2, or 3. Angling the seat will keep the
baby's head back and airway open.
2. Place this restraint in a rear seating position and ensure vehicle is level.
3. Unsnap the 2 front snaps and the 2 side
snaps. Lift and fold back padding.
Copyright © 2018, Baby Trend, Inc.
With headrest
Rear of Vehicle
18