Rear Facing Installation With Lap Belt - Baby Trend Trooper CV01 Owner's Manual

5.0 Installation and Use
4. Use body weight or apply weight in
seat with hand to compress the vehicle
seat cushion then insert the seat buckle
tongue into the buckle and pull seat belt
tight as possible (Fig. 25a). Pull excess
webbing at buckle tongue to tighten.
5. Pull up on buckle to ensure the buckle
is secure. Please refer to the vehicle
owner's manual to determine if your
vehicle lap/shoulder belt includes a
lockable retractor and how to lock it.
6. Ensure the angle indicator bubble is
centered between the lines for children
4-22 lbs. (1.81 - 9.97 kg) to keep the
child's airway open. Ensure the angle
indicator line is level with the ground for
children 23-40 lbs. (10.43 - 18.14 kg) to
keep the child's airway open (Fig. 25b).
7. Check for movement of the car seat
at the safety belt path. The car seat
should not move more than 1 inch in any
direction. If the car seat moves more
than 1 inch, repeat all steps until all
safety steps are met.
25
Fig. 25a
Center bubble for
children 4-22 lbs.
CV0107052419
Fig. 25b
Copyright © 2021, Baby Trend, Inc.

5.3 Rear Facing Installation with Lap Belt.

See section 2.1 for requirements.
• Weight is 4 - 40 lbs (1.81 - 18.14kg).
• Height 1" from top of seatback.
Lap belt
1. Always adjust the recline foot to the recline
position when rear facing. Angling the car seat
will keep the baby's head back and airway open.
2. Make sure vehicle is parked on level ground then, place the car seat
in a rear seating position and ensure vehicle is level.
3. Route Lap Belt through the rear facing belt
paths and under the seat fabric (Fig. 26a).
NOTE: Remove any twist in webbing to
ensure the webbing lies for securing the car
seat to the vehicle.
Copyright © 2021, Baby Trend, Inc.
5.0 Installation and Use
Fig. 26a
26