General Information - Pentair Pentek Intellidrive PID10 Installation And Operation Manual

GENERAL INFORMATION

SPECIFICATIONS
Input Voltage.......................................1-Phase 230VAC Nominal (190–265VAC)
Input Frequency...................................50/60Hz
Ambient Temperate Range...............Less Than 120° F (50° C)
Output Connections..........................3-Phase, 3-Wire/1-Phase or 1-Phase/2-Wire
Max Motor Cable Length...................1,000 FT
Enclosure............................................NEMA 3R
ELECTRICAL SPECIFICATIONS
Model Motor Type*
2-WIRE 1-PHASE
PID10 3-WIRE 1-PHASE
3-PHASE
2-WIRE 1-PHASE
PID20 3-WIRE 1-PHASE
3-PHASE
2-WIRE 1-PHASE
PID30 3-WIRE 1-PHASE
3-PHASE
2-WIRE 1-PHASE
PID50 3-WIRE 1-PHASE
3-PHASE
* Select Intellidrives by S.F. amps of pump motor.
The Pentair Pentek Intellidrive ® Constant Pressure Pump
Controller is specifically designed to operate 4" submersible
pumps and 3-phase above ground pumps in water well and
residential booster applications.
Each Intellidrive is rated for maximum output amp rating.
Any use of it outside of intended design parameters will void
warranty. If Intellidrive is used with above ground motors not
rated for a Variable Frequency Intellidrive, maximize motor life
by limiting lead length to 25 ft.
4
Maximum Input
HP Range
Output AMPS Voltage
0.5–1 HP 9.5A
0.5–1 HP 7.5A
0.5–1 HP 5A
0.5–1.5 HP 11A
0.5–2 HP 13.5A
0.5–2 HP 8.5A
190V – 265V
0.5–1.5 HP 11A
0.5–2 HP 13.5A
0.5–3 HP 11.5A
0.5–1.5 HP 11A
0.5–2 HP 13.5A
0.5–5 HP 18A
Figure 1 - Typical Residential Installation
Refer to pump's Owner's Manual and the National Electrical
Code for proper wire size.
Each carton contains:
Pentek Intellidrive Variable Frequency Drive

Pressure Transducer

10' Pressure Transducer Cable

Quick Start Guide

Installation and Operation Manual

Pentek Intellidrive Model Number Structure

Enclosure
Type
PIDXX
Product Family
PID - Pentek Intellidrive
NEMA 3R
outdoor
HP Range
10 = up to 1.0 HP
20 = up to 2.0 HP
30 = up to 3.0 HP
50 = up to 5.0 HP
The PID10 will operate a 1-Phase 2-Wire, 1-Phase

3-Wire, and 3-Phase motor up to 1HP.
The PID20 will operate a 1-Phase 2-Wire up to

1.5HP and a 1-Phase 3-Wire or 3-Phase motor up
to 2HP.
The PID30 will operate a 1-Phase 2-Wire up to

1.5HP, 1-Phase 3-Wire up to 2HP or 3-Phase motor
up to 3HP.
The PID50 will operate a 1-Phase 2-Wire up to 1.5HP,

1-Phase 3-Wire up to 2HP, or 3-Phase motor up to
5HP.
®
PN957 (25-06-20)