Vibration Response; Noise Emission; Service And Inspection Intervals; Safety Instructions For Maintenance - Siemens SIMOTICS T-1FW6 Series Configuration Manual

3.3

Vibration response

The vibration response of build-in motors in operation essentially depends on the machine
design and the application itself.
As a result of an unfavorable machine design, configuration or system settings, resonance
points can be excited, so that vibration severity level A according to EN 60034-14
(IEC 60034-14) is not reached.
Excessive vibration caused by resonance effects can frequently be avoided by making
suitable settings. Contact Mechatronic Support if you require help in applying remedial
measures. You can find contact data in the Introduction under "Technical Support".
3.4

Noise emission

The following components and settings influence the noise levels reached when built-in
motors are operational:
● Machine design
● Encoder system
● Storage
● Controller settings
● Pulse frequency
As a result of unfavorable machine designs, configuration or system settings, measuring
surface sound pressure levels of over 70dB (A) can occur. Contact Mechatronic Support if
you require help in applying remedial measures. You can find contact data in the Introduction
under "Technical Support".
3.5

Service and inspection intervals

3.5.1

Safety instructions for maintenance

Risk of injury as a result of undesirable rotary motion
If, with the motor switched on, you work in the rotational range of the motor, and the motor
undesirably rotates, this can result in death, injury and/or material damage.
• Always switch off the motor before working in the rotational range of the motor. Ensure
Naturally cooled 1FW6 built-in torque motors
Configuration Manual, 07/2017, 6SN1197-0AE01-0BP3
WARNING
that the motor is in a completely no-voltage condition.
Mechanical properties
3.3 Vibration response
47