Kia CERATO Owner's Manual page 31

WARNING
Never attempt to operate the driver
position memory system while the
vehicle is moving.
This could result in loss of control,
and an accident causing death, seri‐
ous injury, or property damage.
Storing positions into memory
using the buttons on the door
Storing driver's seat positions
1. Shift the shift lever into P (for Au‐
tomatic transaxle / Dual clutch
transmission) or Neutral (for man‐
ual transaxle) while the engine
start/stop button is ON or ignition
switch ON.
2. Press SET button on the control
panel. The system will beep once.
3. Press one of the memory buttons
(1 or 2) within 5 seconds after
pressing the SET button. The sys‐
tem will beep twice when memory
has been successfully stored.
Recalling positions from memory
1. Shift the shift lever into P (for Au‐
tomatic transaxle / Dual clutch
transmission) or Neutral (for man‐
ual transaxle) while the engine
start/stop button is ON or ignition
switch ON.
2. To recall the position in the memo‐
ry, press the desired memory but‐
ton (1 or 2). The system will beep
once, then the driver's seat will au‐
tomatically adjust to the stored po‐
sition.
Adjusting the control switch for the
driver's seat while the system is recall‐
ing the stored position will cause the
movement to stop and move in the di‐
rection that the control switch is
moved.
WARNING
Use caution when recalling the ad‐
justment memory while sitting in
the vehicle. Push the seat position
control switch to the desired position
immediately if the seat moves too
far in any direction.
Easy access function (if equipped)
To provide easier entry to or exit from
the vehicle for a driver, the driver's seat
will be adjusted backwards as far as
the distance set by User Setting on the
Instrument Panel. This occurs when the
driver's door is opened and the Engine
start/stop button is Off with the shift
lever in the P position. If, however, the
distance between the front seat and
back seats are too close, the driver's
seat could fail to adjust itself back‐
wards.
The steering wheel moves to the top.
With the steering wheel moving as far
as top and as far as forward to a driver
on a regular basis (once every 100 igni‐
tions switched on), the steering wheel
identifies and adjusts its location by it‐
self.
The driver's seat and steering wheel
will move back to its original position
when a driver closes a driver's door
with a smart key in his pocket and the
engine start/stop button is in OFF or in
ACC.
You can activate or deactivate this fea‐
ture. Refer to "User settings" on page
4-63.
3
3-09