Oki C650 User Manual page 43

8
When [Are You Sure?] is displayed, check that [Yes] is selected, and press «OK».
9
Wait until the standby screen appears as this machine restarts.
If [Not connected to wireless access point] is displayed, press «OK».
If "Set-up wireless?" is displayed, select [No], and press «OK».
2. Enabling infrastructure
1
Press the scroll button ▼ on the operator panel several times to select [Wireless(Infrastructure)
Setting], and press «OK».
2
Input the admin password using the numeric keypad, and press «OK».
Admin password(P.194)
"It is not possible to use the Wireless(AP Mode) at the same time." will be displayed for about 5 seconds.
3
Press ▲ to select [Enable], and press «OK».
After setting wireless(AP Mode) to [Disable], if a screen appears to ask you to check whether to enable
wireless(Infrastructure), press «OK» to enable wireless (Infrastructure).
To set the IP address of this machine manually, go to "
To obtain an IP address automatically, go to "
The factory default setting is [Auto].
3. Setting the IP address
If you want to set the machine's IP address to a fixed value, follow the procedure below.
 For [Auto], the machine's IP address may change dynamically.
 For [IPv4 Address], set a value which is not overlapped to any other networked machines.
 If you do not use the IPv6 address, set [DHCPv6] to [Disable].
Connecting to the PC after preparing the device
3. Setting the IP address
4. Connecting with the wireless access point
- 43 -
".
".