Configuring Your Wqar (Opc); Using The Front Panel; Upgrading The Wqar Operational Software (Ops) - Teledyne WIRELESS GROUNDLINK WQAR User Manual

Configuring Your WQAR (OPC)

The WQAR has configuration settings which configure it to adapt it to your
aircraft and cellular environment. There are varying methods to change the
WQAR configuration.

Using the Front Panel

Some WQAR settings can be changed through the front panel. These changes
will persist through power cycling. Refer to the following procedures in
Section 4:
•
Set Tail Number
•
View and Set Date/Time
•
Disable Radios
•
Enable Radios
•
Override Run Control

Upgrading the WQAR Operational Software (OPS)

The WQAR operational software (OPS) is available as an LSP and can be
requested from Teledyne Controls. The OPS is installed using the same
methods described above.
Use and disclosure shall be in accordance with the proprietary information notice and DCS on page i.
UG2243800-4XX
P a g e | 16
May 28, 2019