Configuring The 301 - Teledyne TIENet 301 Installation And Operation Manual

Figure 2-7 Attaching the probe to the carrier

2.2 Configuring the 301

Section 2 Installation and Setup for Signature
The mounting rings fit various diameters of round pipes 15"
diameter and smaller. For larger pipes, use the ISCO Scissors
Ring. The mounting rings are held in place by the outward force
of spring pressure in the smaller sizes and by a scissors
arrangement in the larger sizes. For more detailed information
about mounting rings and associated hardware, refer to the
ISCO Mounting Rings user manual, and the instruction sheet
supplied with the mounting ring. After mounting the probe in the
ring or strap, route the cable out of the stream so it will not trap
debris or clog the sewer.
Note
When installing the pH probe and its sensor carrier, make sure
the mounting slots on the carrier are completely pressed into
the mating tabs on the ring. The probe relies on a full engage-
ment between tabs and slots for secure mounting. If the slots
are loose against the tabs, the probe may be swept away by
the force of the stream.
Lastly, remember to unscrew the rubber guard cap from
the sensing end of the probe when it is installed.
To configure the Signature flow meter for operation with a pH
probe using the TIENet 301 device, press
the top menu, and select Hardware Setup. For all TIENet devices
including the 301, select TIENet Setup (Smart Sensor).
TIENet® 301 pH/Temperature Device
(
MENU
) to access
2-7