Fail Indicator - Teledyne WIRELESS GROUNDLINK WQAR User Manual

❖ Middle Section: Displays the status of the airborne data
files such as whether the files are ready for transmission.
➢ RDY: Ready. The WQAR has met the minimum raw data
requirements to transmit data.
➢ RCD: Recording Completion Delay. The WQAR is waiting
for any final data from the acquisition unit before
performing final compression and closing of the data
file. Refer to Section 1 – ACMS Reporting for details.
➢ CMP: Compression. The WQAR is actively compressing
data at this time.
➢ <Blank>: The WQAR is not in any of the above states.
❖ Right Section: Displays the status of the RF Interlocks. Refer
to Section 1 – RF Interlocks for details..
➢ IOn: Interlocks are engaged. The radios are restricted
from receiving power.
➢ IOff: Interlocks are not engaged. The radios are no
longer restricted from receiving power. Figures 4 thru 7
show an example of this.

FAIL Indicator

The WQAR is equipped with an amber-colored FAIL indicator which will
illuminate whenever a hardware fault is detected, configuration files are
missing, or if the internal flight data card is full. The FAIL indicator will also
flash during unit boot up. A list of faults are in Section 5. The FAIL discrete will
usually (but not always) be activated whenever the FAIL indicator is
illuminated.
Use and disclosure shall be in accordance with the proprietary information notice and DCS on page i.
UG2243800-4XX
P a g e | 20
May 28, 2019