F/W Upload Screen; Figure 40 Management: F/W Upload; Table 17 Management: F/W Upload - ZyXEL Communications ZyXEL ZyAIR G-470 User Manual

G-470 User's Guide
You can also press the RESET button on the rear panel to reset the factory defaults of your
device. Refer to

7.4 F/W Upload Screen

Find firmware at
.rmt extension, for example, "zyxel.rmt". The upload process uses HTTP (Hypertext Transfer
Protocol) and may take up to two minutes. After a successful upload, the system will reboot.
Click Management > F/W Upload to display the screen as shown. Follow the instructions in
this screen to upload firmware to your device.

Figure 40 Management: F/W Upload

The following table describes the labels in this screen.

Table 17 Management: F/W Upload

LABEL
File Path
Browse...
Upload
Warning: Do not turn off the device while firmware upload is in progress!
The following screen appears. Click OK to countinue.
Wait until the countdown reaches zero before logging into the device again.
72
Section 4.6.1 on page 49
www.zyxel.com in a file that (usually) uses the system model name with a
DESCRIPTION
Type in the location of the file you want to upload in this field or click Browse ... to
find it.
Click Browse... to find the .rmt file you want to upload. Remember that you must
decompress compressed (.zip) files before you can upload them.
Click Upload to begin the upload process. This process may take up to two
minutes.
for more information on the RESET button.
Chapter 7 Management Screens