Table 7 Wireless: Wireless Settings - ZyXEL Communications ZyXEL ZyAIR G-470 User Manual

The following table describes the labels in this screen.

Table 7 Wireless: Wireless Settings

LABEL
SSID
AP Survey
Wireless Mode
Clone MAC
Address
Advanced Settings
Radio Enable
Output Power
Management
Data Rate
Management
Chapter 6 Wireless Screens
DESCRIPTION
Your ZyXEL Device must have the same SSID as the AP you want to connect to.
Enter a descriptive name (up to 32 printable characters) for the wireless LAN.
Spaces are allowed.
Note: If you are configuring the device from a computer connected
to the wireless LAN and you change the device's SSID,
channel or security settings, you will lose your wireless
connection when you press Apply to confirm. You must then
change the wireless settings of your computer to match the
device's new settings.
Click this button to open the AP Survey window and select an access point.
Select Mixed Mode to set the ZyXEL Device to operate in a wireless network with
both 802.11b and 802.11g wireless devices.
Select Pure B Mode to set the ZyXEL Device to operate in a wireless network with
only 802.11b wireless devices. If you select this, the ZyXEL Device may not
communicate with IEEE802.11g wireless devices
Select Pure G Mode to set the ZyXEL Device to operate in a wireless network with
only 802.11g wireless devices. If you select this, the ZyXEL Device may not
communicate with IEEE802.11b wireless devices
Every Ethernet-capable device is issued with a unique Media Access Control
(MAC) address at the factory. This address is used to identify the device across a
network.
Your ZyXEL Device is capable of "cloning", or emulating, the MAC addresses of
one or more other devices.
Select Auto-Single to have the ZyXEL Device automatically use the MAC address
of a single Ethernet device connected to the ETHERNET port.
Select Auto-Multi to have the ZyXEL Device automatically use the MAC
addresses of multiple Ethernet devices connected to the ETHERNET port via a
hub.
Alternatively, enter a MAC address into the Clone MAC address field and select
Manual to have the ZyXEL Device use that address.
Select Yes to allow wireless communications between the device and other IEEE
802.11b and IEEE 802.11g compliant wireless devices. Select No to stop wireless
communications between the device and other IEEE 802.11b and IEEE 802.11g
compliant wireless devices.
Set the output power of the device in this field. If there is a high density of APs
within an area, decrease the output power of the device to reduce interference with
other wireless LAN devices.
Use this field to select a maximum data rate for the wireless connection.
G-470 User's Guide
59