Security: 802.1X Only; Figure 58 Wireless > Security: Wep; Table 28 Security: Wep - ZyXEL Communications NWA-3160 Series User Manual

Chapter 7 Wireless Security Configuration
Figure 58 WIRELESS > Security: WEP
The following table describes the labels in this screen.

Table 28 Security: WEP

LABEL
Name
Security Mode
WEP Encryption
Authentication
Method
ASCII
Hex
Key 1 to
Key 4
Apply
Reset

7.9.2 Security: 802.1x Only

Select 802.1x-Only in the Security Mode field to display the following screen.
106
DESCRIPTION
Type a name to identify this security profile.
Choose WEP in this field.
Select Disable to allow wireless stations to communicate with the access points
without any data encryption.
Select 64-bit WEP, 128-bit WEP or 152-bit WEP to enable data encryption.
Select Auto, Open System or Shared Key from the drop-down list box.
The default setting is Auto.
Select this option to enter ASCII characters as the WEP keys.
Select this option to enter hexadecimal characters as the WEP keys.
The preceding "0x" is entered automatically.
The WEP keys are used to encrypt data. Both the ZyXEL Device and the wireless
stations must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal
characters ("0-9", "A-F").
If you chose 152-bit WEP, then enter 16 ASCII characters or 32 hexadecimal
characters ("0-9", "A-F").
You must configure all four keys, but only one key can be activated at any one
time. The default key is key 1.
Click Apply to save your changes.
Click Reset to begin configuring this screen afresh.
ZyXEL NWA-3160 Series User's Guide