Security: 802.1X Only - ZyXEL Communications NWA-3166 User Manual

Chapter 10 Wireless Security Screen
The following table describes the labels in this screen.
Table 36 Security: WEP
LABEL
Profile Name
Security Mode
WEP Encryption
Authentication
Method
ASCII
Hex
Key 1 to
Key 4
Apply
Reset

10.2.2 Security: 802.1x Only

Use this screen to set the selected profile to 802.1x Only security mode. Select
802.1x-Only in the Security Mode field to display the following screen.
Figure 79 Security: 802.1x Only
134
DESCRIPTION
Type a name to identify this security profile.
Choose WEP in this field.
Select Disable to allow wireless stations to communicate with the
access points without any data encryption.
Select 64-bit WEP or 128-bit WEP to enable data encryption.
Select Auto or Shared Key from the drop-down list box.
The default setting is Auto.
Select this option to enter ASCII characters as the WEP keys.
Select this option to enter hexadecimal characters as the WEP keys.
The preceding "0x" is entered automatically.
The WEP keys are used to encrypt data. Both the NWA and the wireless
stations must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10
hexadecimal characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26
hexadecimal characters ("0-9", "A-F").
You must configure all four keys, but only one key can be activated at
any one time. The default key is key 1.
Click Apply to save your changes.
Click Reset to begin configuring this screen afresh.
NWA-3166 User's Guide