Ap+Bridge Mode - ZyXEL Communications NWA-3160 Series User Manual

Chapter 6 Wireless Configuration
Table 24 Wireless: Bridge/Repeater
LABEL
TKIP (ZyAIR Series
Compatible)
AES
#
Active
Remote Bridge MAC
Address
PSK
See Table 23 on page 91

6.7.3 AP+Bridge Mode

Select AP+Bridge as the Operating Mode in the WIRELESS > Wireless screen to have the
ZyXEL Device function as a bridge and access point simultaneously. See the section on
applications for more information.
96
DESCRIPTIONS
Select this to enable Temporal Key Integrity Protocol (TKIP) security on your
WDS. This option is compatible with other ZyXEL access points including that
support WDS security. Use this if the other access points on your network
support WDS security but do not have an AES option.
Note: Check your other AP's documentation to make sure it
supports WDS security.
Note: At the time of writing, this option is compatible with
other ZyXEL NWA Series and G-3000/G-3000H access
points only.
Select this to enable Advanced Encryption System (AES) security on your
WDS. AES provides superior security to TKIP. Use AES if the other access
points on your network support it for the WDS.
Note: At the time of writing, this option is compatible with
other ZyXEL NWA-3160 access points only.
This is the index number of the bridge connection.
Select the check box to enable the bridge connection. Otherwise, clear the
check box to disable it.
Type the MAC address of the peer device in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Type a pre-shared key (PSK) from 8 to 63 case-sensitive ASCII characters
(including spaces and symbols). You must also set the peer device to use the
same pre-shared key. Each peer device can use a different pre-shared key.
for information on the other labels in this screen.
ZyXEL NWA-3160 Series User's Guide